Skip to content

Polaris Slingshot with a Turbo 2JZ

Polaris Slingshot with a turbo 2JZ inline-six

Scott Riley set out to create a unique Polaris Slingshot at his company Sport Rider in Altoona, Wisconsin. The project was built to be a raffle prize at a rally event with proceeds going to a charity. Unfortunately in the middle of the build the rally planner informed him the raffle was canceled. Scott decided to continue on and finish what he started.

Polaris Slingshot with a turbo 2JZ inline-six

Scott originally considering powering the Polaris with a LSx V8. However a good friend recommended he look into using an Audi V8. Scott decided against the Audi V8 after researching it. The friend then recommended a Toyota 2JZ inline-six. Scott agreed to the choice after discovering the aftermarket support for the 2JZ and compatibility with the Polaris transmission.

Polaris Slingshot with a turbo 2JZ inline-six

Scott’s Friend found him a Lexus IS300 with a naturally-aspirated 3.0 L 2JZ-GE inline-six and 200,000 miles. Scott turned to his Father, an experienced engine builder to breath new life into the motor. Together they installed Eagle rods, JE pistons with 8.5:1 compression, new valve springs, BorgWarner 66 mm turbocharger, and AEM Inifity ECU.

Polaris Slingshot with a turbo 2JZ inline-six

Polaris Slingshot with a turbo 2JZ inline-six

Scott installed the motor using custom mounts and replacing the front sump oil pan with a rear sump oil pan. He also installed an AEM Carbon 5 digital dash since the factory Slingshot dash would no longer work. The turbocharged 2JZ produces 400 horsepower to the wheels. Scott wants to raise that to 500+ horsepower in the coming months.

Polaris Slingshot with a turbo 2JZ inline-six

Polaris Slingshot with a turbo 2JZ inline-six

The Slingshot’s MA5 five-speed manual is based on the Aisin AR-5 transmission and shares the same bellhousing-to-case bolt pattern. So Scott was able to bolt the Slingshot transmission to the 2JZ using a stock Toyota bellhousing. He upgraded to a Drift Motion Stage 2 clutch and lightweight flywheel.

Polaris Slingshot with a turbo 2JZ inline-six

Polaris Slingshot with a turbo 2JZ inline-six

Scott did not stop at the powertrain. He also installed a custom Ridetech/Accuair suspension by Rev Dynamics in Texas. The system features Shockwave Air Shocks, Accuair E-level controller kit, and two air tanks located next to the driveshaft. The Slingshot rides on a set of Chip Foose F150 Outcast wheels with Hankook Ventus V12 tires.

Polaris Slingshot with a turbo 2JZ inline-six

Polaris Slingshot with a turbo 2JZ inline-six

Polaris Slingshot with a turbo 2JZ inline-six

4 thoughts on “Polaris Slingshot with a Turbo 2JZ”

  1. That looks kool , I have a 2016 and going to put a lm7 with a 4l60e because I like to drive my bike but since I’m handicap and is getting harder to use it , i like to go fast in it , Pete Rodriguez

Leave a Reply to Albert Voll Jr.Cancel reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Discover more from Engine Swap Depot

Subscribe now to keep reading and get access to the full archive.

Continue reading